PS-4660TW
Installation Guide
P. 19
Example: If the multi-level features were set to option 3, the setup would be as follows:
x
Level 1
Æ
Customized feature
x
Level 2
Æ
Multi car operation
x
Level 3
Æ
Basic
features
The “Basic features” are now programmed as level 3 and therefore:
x
To access the aux.2 feature, the user needs to press on the
SHIFT
button three (3) times
followed by the
LOCK
button.
x
To access the status request feature, the user needs to press on the
SHIFT
button three
(3) times followed by the
TRUNK
button.
x
To access cold weather mode, the user needs to press on the
SHIFT
button three (3)
times followed by the
START/STOP
button.
Table 5
Horn Honk Timing
Follow these steps to program Horn Confirmation:
1.
Ensure that the Hood is up and that the Ignition is
OFF
.
•
Hold the Hood Pin-switch down for 4 seconds.
•
Release the Pin-switch. The Parking Lights will come on.
•
While the Parking Lights are on, immediately push and release the
Pin-switch
again.
The Parking Lights will stay on for up to 20 seconds
.
2.
Press and hold the Brake Pedal, then simultaneously press the
UNLOCK
and
START
buttons on the Transmitter –
the Horn will honk 5 times
.
3.
Release the Brake Pedal.
4.
To change the timing:
a.
To increase the Horn pulse by 3 ms, press the
LOCK
button.
b.
To decrease the pulse by 3 ms, press the
UNLOCK
button.
c.
To increase the pulse by 10 ms, press the
START
/
STOP
button.
d.
To decrease the pulse by 10 ms, press the
TRUNK
button.
5.
To save the new settings: press
LOCK
and
UNLOCK
. If 3 honks are returned the new
settings have been saved.
Table 6
Adjusting Honk Duration
Otherwise close the Hood to cancel the changes.
For each timing change, the Horn will honk with the new settings, except in the
following cases:
•
When the lower limit of 5 ms is reached, there will be a 1/4-sec. honk.
•
When the upper limit of 200 ms is reached, there will be a 3/4-sec. honk.
A system reset will set the Remote Car Starter back to the default values: 30 ms.
Tach Programming
About Tach Programming
If you press the
START
button before carrying out a Tach Programming procedure, the
Remote Car Starter will make no attempt to start the Engine and the Parking Lights will
give 5 flashes.
