PS-4660TW
Installation Guide
P. 9
9
PURPLE (–) External
Trigger output
The external trigger wire can be used for remote-
starting the vehicle with an external device. When
the vehicle is running, triggering this input will
activate idle mode. The external trigger wire can also
be used to operate as a negative trigger with the
trunk pin-switch, the key sense wire or the door pin-
switch:
Option 1
Connects to negative trunk pin. When this
wire is programmed for trunk pin, pressing
TRUNK
will
activate a 1-second disarm output. If ground (-) is
detected on the trunk
pin (the trunk has been
opened), an arm pulse will be sent 5 seconds after
the trunk is closes. An arm pulse will be sent 4
seconds after the
TRUNK
button is pressed if the trunk
pin state is unchanged (The trunk was unopened). A
disarm pulse is sent only if the system was
previously locked and armed. If secure lock is
enabled, unlock pulse(s) will be sent with the disarm
pulse, a lock
pulse and a rearm pulse will be sent
when the trunk is closed or if the trunk was left
closed.
Option 2
(Default: engine start/stop): The first
ground (-) pulse on this input will start the engine, the
second ground (-) pulse on this input will stop the
engine.
Option 3
(Key Sense (-) Input): Connects to OEM
key sense wire. When the key is detected in the
ignition switch (ground (-) signal on the OEM key
sense wire) the starter kill will not arm even when it is
set to passive mode. If secure lock is programmed,
lock
and
arm
will not be activated while the key
sense input is active (“active” meaning there is a key
in the ignition barrel).
Option 4
(Smart ignition re-lock): Connects to the
negative door trigger input. When the ignition lock
option or the lock only option is enabled, after the
brake pedal is pressed and after a door has been
opened and closed, the doors will re-lock
.
