Here are the steps which the installer must follow in order to
flash the hood-pin switch
:
The installer …
The module …
1.
Press and hold the hood-pin switch for 4
seconds.
2.
Release
the hood-pin switch.
The parking lights will turn
ON
.
3.
While the parking lights are
ON
,
press down
the hood-pin switch once more.
4.
Release
the hood-pin switch again.
Caution!
If you press down and release the
hood-pin switch too many times, you will
enter diagnostic mode
rather than
programming mode.
The parking lights will stay
ON
for 20 seconds
5.
You now have 20 sec. to select one of the
sub-menus.
Table 1: Flashing the hood-pin switch
Once the module has entered programming mode, you will have a selection of many
different sub-menus, which will be described later in this guide:
a. Transmitter Programming .....................................p.14
b. Programming Options...........................................p.16
c. Honk/Horn Timing (if available).............................p.19
d. Tach Programming ...............................................p.17
Remember:
Once the Parking Lights are
ON
(solid), you have up to 20 seconds to select
a sub-menu. If you do not select a sub-menu within 20 seconds, the Remote
Car Starter will exit Programming Mode and you will have to flash the Hood
Pin switch once again.
The Programming Assistance Button
(A.k.a. the
PAB
.) Mounted on the Remote
Car Starter, this button can be used from
within the vehicle instead of the Hood Pin
switch in the Engine compartment. This will
spare the installer the trouble of accessing
the Hood Pin switch in the Engine
compartment.
Caution
The Hood Pin switch must be installed and connected in order for the
Programming Assistance Button to function.
The button will work only
when the Hood is up.
PS-4660TW
Installation Guide
P. 13
