PS-4660TW
Installation Guide
P. 21
Tach Adjustments
After having programmed the tach you might need to adjust it (increase or decrease
the idle speed). In order to do so, you will need to follow these steps:
1-
Flash the hood pin (see page 12)
2-
Enter the programming centre (see page 14).
3-
Press
and hold
the brake pedal
4-
Press simultaneously the
LOCK
and
UNLOCK
buttons.
5-
With the brake pedal still pressed,
a.
Press
UNLOCK
to decrease the idle speed, or,
b.
Press
LOCK
to increase the idle speed.
6-
Once you have obtained the desired idle speed, press
TRUNK
to save the new
settings. The parking lights will flash five times. If the horn has been
configured you will hear one honk if the last button pressed was
LOCK
and two
honks if the last button pressed was
UNLOCK
.
7-
Release the brake pedal and close the hood.
8-
The adjustment is done.
Table 9
Testing
Before putting back the vehicle together, it is recommended to check that the system
operates properly. The following testing procedures should be used to verify proper
installation and operation of the system. Before testing, make sure that all connections
are soldered and that the unit is plugged in.
Make sure the Remote Car Starter properly
enters and exits Ready Mode
:
Setting the system to Ready Mode
1.
Ensure that all the Doors are closed and that the gear selector lever is in the
neutral position.
2.
With the Engine already running, apply the Parking Brake and release the Brake
Pedal.
Make sure to release the Brake Pedal.
3.
Within 20 sec. push
LOCK
,
UNLOCK
or
START
on the Transmitter.
The Parking Lights will flash 3 times quickly and remain lit.
4.
Remove the key: the Engine will go on running.
5.
Exit the vehicle and close the Door.
6.
Press and hold either:
a.
LOCK
to lock the Doors and shut down the Engine or enter Turbo Mode ;
b.
UNLOCK
to unlock the Doors and shut down the Engine or enter Turbo Mode ;
c.
START/STOP
to shut down the Engine without affecting the Doors.
Table 10
Entering Ready Mode
