P. 8
Installation
Guide
PS-4660TW
Caution!
The installer should use
either
the positive
or
the negative Door input. Never use both of them
simultaneously.
It is essential that the Remote Car Starter be
connected in such a way as will allow
each one of
the Doors
to turn off Ready Mode: the
driver-side
Door Pin does not constitute by itself a
sufficient connection
.
7
WHITE /
ORANGE
(–) Starter Kill
output
(armed
output)
This wire will provide a constant 500 mA output when
the system is armed
(locked by remote control). It
can be connected to an external starter interrupt
relay. This wire should be connected to a single pole
double-throw relay: this wire will connect to pin 85 on
the relay, and pin 86 will be connected to the ignition
wire. The starter kill output becomes active during
remote starts. One benefit of the starter kill is the
anti-grind feature. Once the vehicle has been remote
started, the anti-grind prevents the starter motor from
re-engaging when the ignition key is inserted in the
ignition switch and accidentally turned to the
CRANK
position
.
8
ORANGE (–) Parking
Brake input
Connect to the negative Parking Brake Indicator Light
wire of the vehicle. This wire is found at the parking
brake lever itself.
Note:
The wire should test ground when the Parking
Brake is engaged.