97
will go out. You can activate automatic switching into the ПОДОГРЕВ / KEEP WARM mode again later by pressing the
“ДАВЛЕНИЕ / ОТМЕНА ПОДОГРЕВА / PRESSURE / CANCEL KEEP WARM” touch button.
- If necessary, the program’s execution may be canceled by pressing the “СТАРТ / ОТМЕНА / START / CANCEL” touch
button. In doing so the appliance will switch to standby mode.
- The multicooker will give off a sound signal upon completion of the program. The appliance will automatically switch
into the ПОДОГРЕВ / KEEP WARM mode unless it was previously disabled. In the ПОДОГРЕВ / KEEP WARM mode, the
display will show the forward time count (in hours) indicating the dish’s heating time.
- To turn the heating mode off, press the “СТАРТ / ОТМЕНА / START / CANCEL” touch button and the appliance will
switch into standby mode. Turn off the appliance.
Advice:
the liquid level must not exceed maximum capacity.
Pizza
This program is intended for preparing a popular Italian dish: pizza.
- Turn on the appliance. The display illumination will light up.
- Place all desired contents into the bowl according to the recipe. Follow the instructions in the “Appliance operation”
section.
- It is best to keep the lid closed while cooking with this program. If the lid is not in proper position, it might not turn
out as well.
- Select the “Pizza” program from the general program list by pressing the “МЕНЮ / MENU” or the “+ and -” touch
buttons. The “Pizza” display indication will start blinking.
- The ДАВЛЕНИЕ / PRESSURE mode is not available in this program.
- The default cooking time for this program is 35 minutes. Set the cooking time according to the dish’s recipe: press
the “ВРЕМЯ / ТЕМПЕРАТУРА / TIME / TEMPERATURE” touch button, then change time setting in 5 minute increments
by pressing the “+ and -” buttons. The time may vary in the 20 minutes to 1 hour range.
- You will not be able to adjust the temperature settings in this program. The default temperature will be 120°С. To
adjust the temperature, press the “ВРЕМЯ / ТЕМПЕРАТУРА / TIME / TEMPERATURE” button and use the “+ and -”