
77
• After the program completes, the multicooker will switch into the Подогрев / Heating mode (unless
it was previously disabled). The display shows a 0 (or a number of hours in this state) in the rightmost
digit of the timer indicator, the Подогрев / Heating notice, and the “program complete” indicator.
This mode may be disabled by pressing the “СТАРТ / ОТМЕНА / START / CANCEL” touch button.
• The melody sound also confirms the lid handle’s switching between the open and closed positions
when the program is running without pressure or during mode selection.
• A sharp signal sounds if the lid handle is turned into the “Open” position when a program with
pressure is running (it is possible if a temperature lower than 100 degrees is set and there is no
excess pressure in the appliance). The program selected will be reset in this case and the appliance
will switch into standby mode.
• Two L’s facing each other in the two rightmost time digits of on the multicooker displayed during
an attempt to start a program indicate that the removable bowl is missing. In this case, you will not
be able to start a program.
• The “Error” notice on the display indicates a failure of the multicooker’s electronics and you will
be required to contact the service center.
• Approximately 3 minutes before a program entailing pressure ends, a warning signal will sound
and the program will then automatically enable the pressure release valve. Steam will be released
through the holes in the steam release device. Please be careful during this moment and do not
place your hands or other parts of your body close to the steam release device. The pressure
will be released and by the time the program ends, you will be able to turn the lid handle into the
“Open” position and then press the lid opening button to access to the inner bowl. If the pressure
is not released for some reason and the handle does not turn easily, do not apply force to turn it.
Instead, wait some time for steam to be released and then turn the handle.
If steam starts to profusely escape from under the pressure valve leading to rotation of the