1700-GB zusinfo / Ba-el allG.
EN
- Z.58 -
Important addItIonal InformatIon for your safety
- 58 . Section 1 -
Combination of tractor and mounted implement
DANGER
life hazard or material hazard - due to overload on tractor or wrong tractor ballast distribution.
•
Make sure that hitching the implement (in the front and rear three-point linkage) does not lead to exceeding the maximum
total admissible weight of the tractor, the axle loads or the load capacity of the tyres. The front axle of the tractor must
always to be loaded with at least 20 % of the unladen weight of the tractor.
•
Make sure before buying an implement that these conditions are fulfilled by carrying out the following calculations or by
weighing the tractor/implement combination.
Determination of the total weight, the axle loads, the tyre load carrying capacity and the necessary
minimum ballasting.
see instruction handbook of the tractor
see price list and/or instruction handbook of the implement
to be measured
Rear hitched implement resp. front-rear combinations
1.
CALCULATION OF MINIMUM BALLASTING AT THE FRONT G
V min
Record the calculated minimum ballasting which is needed at the front of the tractor into the table.
Front mounted implement
2.
CALCULATION OF THE MINIMUM BALLASTING REAR G
H min
Record the calculated minimum ballasting which is needed at the rear of the tractor into the table.
For the calculation you need the
following data:
T
L
[kg]
T
V
[kg]
T
H
[kg]
G
H
[kg]
G
V
[kg]
unladen weight of tractor
front axle load of unladen tractor
rear axle load of unladen tractor
combined weight of rear mounted implement/rear
ballast
combined weight of front mounted implement/
front ballast
distance from centre of gravity for
combined front mounted implement/front
ballast to front axle centre
Tractor wheelbase
distance from rear axle centre to centre
of lower link balls
distance from centre of lower link balls
to centre of gravity for combined rear
mounted implement/rear ballast
a
[m]
b
[m]
c
[m]
d
[m]
2
3
1
1
1
1
1
2
2
2
3
3
1
3
2
