- 12 -
2000-EN_Schleppervoraussetzungen_2860
EN
TracTor requiremenTs
Tractor
The following tractor requirments are necessary to operate
the implement:
- Tractor output:
TOP 662:
from 44 kW / 60
PS
- Attaching:
Lower link Cat. II
- Connections:
see "Required hydraulics and Electrical
Connections" table"
Ballast weights
Ballast weights
The front of the tractor must have sufficient ballast weights
to guarantee braking and steering capabilities.
DANGER
life hazard or material hazard - due to wrong tractor
ballast distribution.
•
The front axle of the tractor must always be
loaded with at least 20% of the tractor's tare
weight to guarantee the steering and braking
capacity of the tractor/trailer unit.
20%
Kg
lifting unit (three-point linkage)
371-08-16
371-08-16
- The tractor’s lifting unit (three-point linkage) must be
designed for the occurring load. (See technical data)
- The lifting struts are to be set at the same length (4)
using the appropriate adjusting device
(See the tractor manufacturer’s operating manual)
- Select the rear position if the lifting rods can be set in
various positions on the lower link. This relieves the
pressure on the tractor’s hydraulic system.
- The limiting chain or lower link stabilisers (5) are to
be set so that the attached machine CANNOT move
sideways. (Safety measure for transportation)
Hydraulic control on the lifting gear
The lifting hydraulics shall be switched on
position control:
- for transportation
- when (un)attaching the machine
- after switching off the control panel
