Copyright Planika Sp. z o.o.
www.planikafires.com
IG0139#02
30.07.2018
52
6.
CONTROL
The unit is supplied with remote control for the user(Picture 20 "B"), which controls the receiver and allows
you to turn on and off the fireplace, and to adjust the height of the flame. Control method using the remote
control as well as a description of the device is described in the User Manual. Optionally, orange remote
control for the installer can also be supplied (Picture 20 "O").
The remote control receiver is installed in the inspection hatch next to the gas assembly. Exposure of the
system’s electronic to temperatures exceeding 60 ° C will result in irreversible damage. The maximum distance
between the inspection hatch and the device is determined by the length of flexible gas hoses and wires
connecting the controller with the electrodes of the hearth. Do not extend the cables supplied with the unit,
as this may affect the malfunction of the control system. Keep in mind not to put the ignition wire too close
to metal parts. Elements of the system cannot be exposed to moisture, dust, and the factors affecting the
formation of corrosion. If you need to replace the individual system components, use only original parts
available for purchase from the Manufacturer. Plugs of the individual wires are chosen in such way, as to
prevent incorrect connection components.
6.1.
Remote controls
6.1.1.
Remote control for the user.
To prepare remote control to use, follow these steps:
Place the two batteries (AA) attached to the device inside the remote control.
Make sure that the device is not turned off for more than 5 minutes.
When you first start the device (or if the power supply was switched off for more than 5 minutes), you
must configure the connection of the remote control with the device.
If the remote control is not in the mode of establishing the connection to "BND", follow these steps:
o
Press the menu button (the button with a square symbol) on the remote control for at least 10
seconds and then press it several times until "BND" inscription with symbol of reception
appears on the screen.
o
Press briefly and simultaneously buttons "arrow up" and "down arrow" so the blinking warning
triangle and hourglass also appear on the screen.
o
Startup screen display means the end of the login process and configured remote control which
is now ready to work with a fireplace.
WARNING!
All functions are explained in detail with supplied User Manual.
