> GARP Leave Timer – The interval a port waits before leaving a VLAN group.
This time should be set to more than twice the join time. This ensures that
after a Leave or LeaveAll message has been issued, the applicants can rejoin
before the port actually leaves the group. (Default: 60 centiseconds)
> GARP LeaveAll Timer – The interval between sending out a LeaveAll query
message for VLAN group participants and the port leaving the group. This
interval should be considerably larger than the Leave Time to minimize the
amount of traffic generated by nodes rejoining the group. (Default: 1000 cen-
tiseconds)
> Trunk Member – Indicates if a port is a member of a trunk. To add a trunk to
the selected VLAN, use the last table on the VLAN Static Table page.
> Mode – Indicates VLAN membership mode for a port. (Configure via CLI, see
page 3-95.)
>> 1Q Trunk – Specifies a port as an end-point for a VLAN trunk. A trunk is a
direct link between two switches, so the port transmits and receives
tagged frames that identify the source VLAN.
>> Hybrid – Specifies a hybrid VLAN interface. The port may receive or trans-
mit tagged or untagged frames. Any frames that are not tagged will be
assigned to the default VLAN.
Mode and the Acceptable Fame Type are comparable parameters.
71