Pitney Bowes Relay 2500, User Manual

Page: 113 / 182

OMR Scanning Error Messages
Message Action
Bad OMR marks Spacing Two marks that are closer together than half the expected distance are read. Check scan
marks on material
No OMR marks - No marks on paper
- Scan sensor is not centered over scan marks
- Paper not loaded correctly
Bad OMR Code length Code type on paper does not match the setup. (Example: setup has OMR+ Sequence
but paper has OMR + Select Feed + Sequence )
Bad OMR Code format Re-timing scan mark is missing; check material. (Example: mark 6 missing from 10 mark
code)
Expected 1st Sheet of set BOC mark (position 4) was present when not expected. First page of the set was
expected
Not a new Envelope BOC mark (position 4) absent when it was expected; pages other than the first of set
were expected
OMR: Parity Error Code doesn't have an even number of marks
OMR: Sequence Error Sequence number is not sequential with the previous page fed. Therefore, sheets are in
the wrong order or missing
OMR: SF marks Inconsistent Selective feed and Autobatch marks at positions 7 to 9 are different from those on the
previous sheet of this set
OMR: SF not in Use Selective feed mark is present at positions 7 to 8, but the job setup does not include
select feed
OMR: Set too Large The set contains too many sheets from the main feeder.
OMR: End of Batch
Ready to Run
- Inserter has stopped for “End of Batch"
- Allows the operator to manually sort envelopes
Mode Change Recheck
Feeders
Scroll at least to the paper length setting before the system accepts the job setup.
OMR Scanning
Pitney Bowes Relay™ 2500, 3500, 4500 User Guide December, 2018 Page 106 of 174