Pioneer XY-122, Installation Manual

Page: 33 / 92

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Procedure (CP-XY12AB1/CP-XY15AB1)
(1)
(2)
(3)
(4)
(5)
(6)
Note: For larger down-tilt angles, position the pivot on the last hole and use
the point on the rear or underside as a pull-back.
The hole (φ13) on the hook-clamp(B) can be used to install the speaker to
the ceiling. (Fig.3-2-3-D)
Remove the pre-inserted M10 mounting screw on the either right or left
mounting point on the top of the XY-122/152 enclosure.
Ensure the commercially-available eyebolt are secured to either right or left
mounting point on the top of the enclosure to suspend it with wire as a
secondary safety feature. (Fig.3-2-3-E)
Remove the two pre-inserted mounting screws on the top of enclosure.
(Fig.3-2-3-B)
Using the supplied M10 hex head bolts(D), align the mounting holes in the
Variable angle bracket(A) with the mounting points on the top of the
enclosure.
WARNING: Please look carefully at the illustration below before installing
the Variable Angle Bracket to the enclosure and place the Variable Angle
Bracket in the right position to align its front and the top front of the
enclosure.
Ensure that both the Spring washers(E) and Flat washers(F) are used - the
Flat washer(F) should be in contact with the bracket. Tighten the bolts at
15N·m torque. (Fig.3-2-3-C)
Using the socket head bolt(C) and the Nut(G), attach the hook-clamp(B) to
the mounting point. Moving the pickup point to the rear of the enclosure
will add down-tilt, and moving to the front of the enclosure will apply up-tilt.
Ensure that two Flat Washers (F) are used between the Hook-clamp(B) and
M10 socket head bolt(C) as well as the nut(G) and the hook-clamp(B).
(Fig.3-2-3-D)
Commercially
-available
eyebolt
Fig.3-2-3-E
Fig.3-2-3-C
NOTE: XY-122 is shown in the illustration.
(A)
(E)
(F)
(D)
Front Back
CP-XY12AB1
Fig.3-2-3-B
CP-XY15AB1
Front Back
3pcs
2pcs
Wide
Narrow
NOTE: A product label is stuck on the front of the
angle bracket.
(C)
(B)
(G)
(F)
(F)
Fig.3-2-3-D
http://pioneerproaudio.com/
Page 33 / 92
©2018 Pioneer DJ CORPORATION