Pioneer XY-122, Installation Manual

Page: 27 / 92

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
(2)
(3)
(4)
(5)
(6)
XY-122:
Using the supplied M10 hex socket head bolts(B), align the mounting
holes in the end mounts of the plate of the Horizontal Flying Cradle(A)
with the mounting points on the top and the bottom of the enclosure.
Ensure that both Spring Washer(C) and Flat washer(D) are used - the
Flat Washer(D) should be in contact with the cradle. Tighten the bolts
at 15N·m torque. (Fig.3-2-2-C)
Using the supplied 4 bolts(B), align the mounting holes in the end
mounts of the plate of the horizontal Flying Cradle(A) with the
mounting points on the top and the bottom of the enclosure. The
installation method depends on the model you use. Please follow the
steps below for further details when installing such a model.
XY-81/101:
Using the supplied M8 countersunk bolts(B), align the mounting holes
in the end mounts of the plate of the Horizontal Flying Cradle(A) with
the mounting points on the top and the bottom of the enclosure.
Tighten the bolts at 7N·m torque. (Fig.3-2-2-C)
XY-152:
Using the supplied M10 hex socket head bolts(B), align the mounting
holes in the end mounts of the plate of the Horizontal Flying Cradle(A)
with the mounting points on the top and the bottom of the enclosure.
WARNING:
The mounting plate of Horizontal Flying Cradle should be installed to
the XY-152 enclosure in a specific orientation. Please see Fig.3-2-2-D to
install the Horizontal Flying Cradle in the correct orientation.
Ensure that both Spring Washer(C) and Flat washer(D) are used - the
Flat Washer(D) should be in contact with the cradle. Tighten the bolts
at 15N·m torque. (Fig.3-2-2-C)
Once the desired angle of the loudspeaker is set, tighten the
knobs/levers on the cradle to lock the position in place. (Fig.3-2-2-E)
The holes on the top of the horizontal Flying Cradle(A) can be used to
install the speaker to the ceiling or the wall in the horizontal position.
(Fig.3-2-2-E)
Remove the two mounting screws pre-inserted in the holes on the rear
side of enclosure.
Ensure the two commercially-available eyebolts are secured to the rear
points on the enclosure to suspend it with wire as a secondary safety
feature. (Fig.3-2-2-F)
(B)
(C) (D)
(A)
Fig.3-2-2-C
Commercially
-available
eyebolt
Fig.3-2-2-E
Fig.3-2-2-F
NOTE: XY-122 is shown in the illustration.
Fig.3-2-2-D
SHORT
SIDE
LONG
SIDE
FRONT BACK
3 x φ13
http://pioneerproaudio.com/
Page 27 / 92
©2018 Pioneer DJ CORPORATION