Chapter 5: System Maintenance
62
Deko1000 & Deko550 Technical Reference And Service Guide
9. Push the DVD/CD Floppy Assembly from the back to slide it out of the workstation.
Push the assembly from its back, and then grab its front to slide it out of the workstation.
Take care that the dual-wire USB cable does not snag or pull other connected wires loose
when the assembly is being removed. Refer to Figure 5-22.
Figure 5-22: Removal of DVD/CD and Floppy Drive
10. If the DVD/CD Drive is to be replaced, remove the screws securing the DVD/CD
Drive in the DVD/CD Floppy housing assembly.
There are 2 screws on the top side of the housing and 2 screws on the bottom side of the
housing that keeps the DVD/CD Drive in place. Refer to Figure 5-23. Remove the
screws.
Figure 5-23: Bottom of DVD/CD Floppy housing assembly
11. If the Floppy Drive is to be replaced, remove the screws securing the Floppy Drive in
the DVD/CD Floppy housing assembly.
There are 4 screws on the top of the housing and 4 screws on the bottom of the housing
that keeps the Floppy Drive in place. Refer to Figure 5-23. Remove the screws.
12. Remove the malfunctioning drive from the housing assembly, and replace with the
new DVD/CD or Floppy drive.
Once the malfunctioning DVD/CD or Floppy drive’s securing screws have been removed
from the housing assembly, the drive can simply be pushed out of the front of the housing
