Chapter 3: Installation And Setup
20
Deko1000 & Deko550 Technical Reference And Service Guide
4. Attach the front panel cover (supplied) to the front of the Deko1000 or Deko550 work-
station.
The panel cover is the large plastic front panel cover that has the word Deko in red lettering.
5. Connect a monitor (not supplied) to the Deko1000 or Deko550 workstation.
The monitor attaches to the SVGA connector on the back of the Deko1000 and Deko550
Workstation. Refer to Figure 3-2.
6. Connect both AC Power Cords (supplied) the Deko1000 or Deko550 workstation.
The AC power cords connect to both Power Supplies located at the back of the workstation.
Refer to Figure 3-2. Use the power cords appropriate for the electrical voltage range used by
the electrical outlet.
7. Turn on the monitor, and then power up the Deko1000 or Deko550 workstation.
The workstation is power up by first pushing the Power Supply switches where the AC
Power Cords are connected to “On.” Then push the On/Off button located on the front panel
of the workstation to power up the workstation. When the operating system boots up, the
Deko1000 or Deko550 background is displayed on the monitor.
8. Run the automatic mode of the Inflexion I/O Diagnostic Utility to insure that the
TARGA card(s) are functioning on the workstation.
For each TARGA card to be tested, the SDI channels for that card must be set to loop back.
This is done by taking two BNC cables (75 ohm) and connecting the Input/Output of each
channel as shown in Figure 3-3. The TARGA card BNC connectors are located on the back
panel of the workstation. The cable connection on the card for the test should be: Video Out
to Video In, and Key Out to Key In. Refer to Figure 3-3.
Figure 3-3: Loop Back Connections on each SDI channel
Navigate the following path to the Inflexion Diagnostic software program within Windows:
Start menu >> Programs >> Deko1000 or Deko550 >> Diagnostic Tools
Then click the program “Inflexion I-O Diagnostic” to open it. Refer to Figure 3-4.
VIDEO IN
VIDEO OUT
KEY IN
KEY OUT
