29
12.15.
System information
Provides general information for the visualization and control system.
12.16.
Software update
Mask is not available in the web application.
With this mask, a new software version can be uploaded
onto the system via USB stick.
Information
The USB stick prepared as update stick is required.
It is recommended to save all parameter of the system before updating the software
In addition to the current software version, a potentially new version is displayed, in case one has
been found.
Information
Wait 30 seconds after inserting a USB stick so that the data medium can be recognized by the system.
In order to then carry out the update of the software, proceed as follows:
1)
Switch the system operating mode to Standby..
2)
Plug the USB stick into the operating unit.
3)
Save the parameters (see Save/Load parameters)
4)
Restart the system or select
Start update
on mask
Software update
to start
the update. This may take several minutes.
5)
During the subsequent start up all I/O devices are updated if necessary.
Finally, the system starts and the updated visualization software will be displayed. Now it is allowed to
remove the USB stick that was used for the update.
12.17.
Factory settings
Is not available in the web application.
This sets all parameters and system settings, but no operational data, back to the original state at the
time of delivery (module type and quantity [e.g. two heating circuits] and parameters to default
settings). Following the confirmation of the opening dialog box, all factory settings will be loaded.
When resetting the factory settings with User Level 3 also the operational data (e.g. system statistics)
are deleted. After setting to factory settings, a new setting-up of system must be performed.
