Philips System4 LTC 2650/00, User Manual

Page: 70 / 76

70
■
4x4 (3x3) Display on Monitor A : This button will cause Monitor A to display the 4x4 Mode in a Duplex System4 or a
Simplex System4 that is not in Record (for a Simplex System4 in Record, this button is grayed out). The 3x3 Display mode
applies to the nine-channel model.
This will enable you to easily see what other cameras might be under alarm and/or to see the video from the other cameras in
the system. To control a camera other than the one generating the currently active event, you must either return to the
Philips
GUI , or select the Monitor A Application .
■
Digital Zoom : This button will cause Monitor A to display the camera under action or alarm in 2:1 digital zoom mode.
■
Monitor A Application : This button opens up the Monitor A Application for the corresponding System4 box. This enables
you to acknowledge multiple alarms, and/or actions without having to click on each of the individual Event Handler Hot
buttons. This is an option unique to the System4 , since it can display the multiscreen (such as the 4x4 mode) where each of
the camera's video and alarm/action status is displayed at once.
5.2.3 Camera Control Group
This is a variable speed Pan and Tilt control. Movement is possible by two
different methods. The first method is to select the ball in the center by
clicking on the left mouse button, holding the button down, and moving the
ball in the direction you want the camera to move. As you get closer to the
edge of the Pan and Tilt field, the faster the camera will move. The second
method is done by clicking anywhere in the PTZ field. The ball will move to
that spot, and the camera will move in that direction. Once again, the further
you get to the edge, the faster the camera will move.
■
On the zoom, iris, and focus buttons, select using the left mouse button.
The lower portion of the button decreases and the upper portion increases.
■
Zoom : If the camera displayed in the active cameo has a zoom lens and the
System4 biphase output is wired to it, this button zooms the lens in and
out.
■
Iris : If the camera displayed in the active cameo has a lens with a remotely
controlled iris and the System4 biphase output is wired to it, this button
opens and closes the iris.
■
Focus : If the camera displayed in the active cameo has a lens with remotely
controlled focus and the System4 biphase output is wired to it, this button focuses the lens far and near.
■
To select a pre-position set in the dome camera, select the Shot button and a dialog box will open up letting you enter a value
for the pre-position.
■
To send Auxiliary Commands, select either the On or Off keys and type in the corresponding auxiliary command that you
want (only up to four characters allowed).
■
To create a pre-position from the Control Panel , move the camera to where you would like to create the pre-position, select the
Set button, and enter in a number for this pre-position that you want to create.
LTC 2650 S
YSTEM
4 M
ULTIPLEXER
GUI A
LARM
H
ANDLING
PTZ Control Panel