68
4.7.4
Pan/Tilt/Zoom (PTZ) Control
This is a variable speed Pan and Tilt control. Movement is possible by two
different methods. The first method is selecting the ball in the center by
clicking on the left mouse button, holding the button down, and moving the
ball in the direction you want the camera to move. As you get closer to the
edge of the Pan and Tilt field, the faster the camera will move. The second
method is done by clicking anywhere in the PTZ field. The ball will move to
that spot and the camera will move in that direction. Once again, the further
you get to the edge, the faster the camera will move.
■
On the zoom, iris, and focus buttons, select using the left mouse button,
using the lower portions to decrease and the upper to increase.
■
To select a pre-position set in the dome camera, select the
Shot
button. A
dialog box will open up, letting you enter a value for the pre-position.
■
To send Auxiliary Commands, select either the
On
or
Off
keys and type in
the corresponding auxiliary command that you want (only up to four
characters allowed).
■
To create a pre-position from the
Control Panel
, move the camera to where you would like to create the pre-position, select the
Set
button, and enter in a number for the pre-position that you want to create.
4.7.5
Monitor B Application Status Line
The status line indicates the current Operating Mode of the LTC 2600. On a Simplex Model, Monitor A can be Live, Playback, or
Record. A Duplex Model Monitor A can be Live, Playback, Record, and Playback/Record.
For a Simplex model, Monitor B will always be Analog. For a Duplex model, Monitor B can be Analog, Live, or Record. Note
that when Monitor A is in Record and Monitor B is dedicated to the VCR (Record), the Monitor B application cannot run, and
Monitor A can only display in Analog mode.
When Monitor A runs in Analog mode, many capabilities (Multimode Screens, Freeze, etc.) are disabled. These selections are
grayed out, and the lower left portion of the status line text indicates that Monitor A is an analog display.
LTC 2650 S
YSTEM
4 M
ULTIPLEXER
GUI
M
ONITOR
A
PPLICATIONS
PTZ Control Panel
Summary of Contents for System4 LTC 2650/00
Page 75: ...75 ...
