6. Two WiFi modes:
Ad
-
hoc mode:
On your device (phone, laptop etc.):
15 seconds after powering up your A035, scan for
WiFi networks and select the SSID similar to
‘
QK
-
A035xxxx
’.
Connect to
‘
QK
-
A035xxxx
’
with the de-
fault password:
‘88888888’.
Chart software:
in your chart software, set the
protocol to
‘
TCP
’,
IP address to
‘
192.168.1.100
’
and
port number to
‘
2000
’
Station mode: please use the configuration software
to change WiFi connection type to station mode.
Disclaimer:
This product is designed to aid navigation and should be used to augment normal navigational
procedures and practices. It is the user
’
s responsibility to use this product prudently. Neither Quark
-
elec, nor
their distributors or dealers accept responsibility or liability either to the product user or their estate for any
accident, loss, injury or damage whatsoever arising out of the use or of liability to use this product.
Email:
info@quark
-
elec.com
V1.1(12/21)
QK
-
A035
Note:
SeaTalk
™
is a registered trademark of Raymarine.
USING THE CONFIGURATION SOFTWARE (WINDOWS):
WiFi connection mode can be changed from Ad
-
hoc (default) to station or standby mode.
Station mode
can be configured by inputting your router/access point
’
s details into the configu-
ration software. (Once configured, the correct settings must be entered into your chart software.)
Filtering: using the black list function
If required, selected NMEA sentences can be filtered out from the chosen inputs, using the
’
black
list
‘
field. Remove the
‘$’
or
‘!’
from the 5 digit NMEA talker and sentence identifier and insert
them separated by commas. E.g. to block
‘!
AIVDM
’
and
‘$
GPAAM
’
enter
‘
AIVDM,GPAAM
’ .
Up to 8 sentences types can be filtered from each input port. For blacklisting Seatalk
¹
data, block
the corresponding NMEA message (see the manual for a full list of converted messages).
Routing the Seatalk and NMEA sentences.
As a default, all inputs
’
data (excluding any filtered data) is routed to all outputs (NMEAx4, WiFi
and USB). Data can be routed to limit the data flow to only certain output/s by un
-
ticking the
corresponding boxes in the configuration software.
NMEA Baud rates:
Default Baud rates are set to:
•
NMEA IN 1,2,3: 4800bps
•
NMEA IN 4: 38400bps
•
NMEA OUT 1,2: 4800bps
•
NMEA OUT 3,4: 38400bps
These can be changed as required.
USB input:
The USB connection is 2 way as standard, no additional configuration required. Man-
ual NMEA input via USB is also possible through the configuration software. A good understand-
ing of NMEA sentence structure is required for this additional function.
SET
-
UP GUIDE
QK
-
A035
NMEA 0183 4X4 MULTIPLEXER
WITH SEATALK
™
CONVERTER
AND INTEGRATED VDR
All products are CE, RoHS certified
More information at www.quark
-
elec.com
Please recycle your packaging
