6. WiFi Ad-hoc connection
On your device (phone, laptop etc.):
15 seconds after the A033 has powered up, you
can scan for a WiFi network with an SSID similar to
‘QK-A033xxxx’. Connect to ‘
QK-A033xxxx
’ with
the default password: ‘
88888888
’.
Chart software:
in your chart software, set the
protocol to ‘
TCP
’, IP address to ‘
192.168.1.100
’
and port number to ‘
2000
’
For Station mode WiFi setup, use the Configura-
tion software. (see below)
Disclaimer:
This product is designed to aid navigation and should be used to augment normal navigational
procedures and practices. It is the user’s responsibility to use this product prudently. Neither Quark-elec, nor
their distributors or dealers accept responsibility or liability either to the product user or their estate for any
accident, loss, injury or damage whatsoever arising out of the use or of liability to use this product.
Email:
V1.1(10/19)
QK-A033
Note:
SeaTalk™ is a registered trademark of Raymarine.
USING THE CONFIGURATION SOFTWARE (WINDOWS):
WiFi can be changed from Ad-hoc (default) to Station mode or Standby.
Station mode
is configured by inputting your router/access point’s details into the Configuration
software. (once configured, the correct settings must be entered into your chart software.)
Filtering: using the black list function
If desired, selected NMEA sentences can be blocked from chosen input/s, using the ’black list ‘
field. Remove the ‘$’ or ‘!’ from the 5 digit NMEA talker and sentence identifier and insert sepa-
rated by commas. For example to block ‘!AIVDM’ and ‘$GPAAM’ enter ‘AIVDM,GPAAM’ .
Up to 8 sentences types can be filtered from each input port. If blacklisting Seatalk data, block
the corresponding NMEA message (see the manual for a full list of converted messages).
Routing the Seatalk and NMEA sentences.
As a default, all inputs’ data (excluding any filtered data) is routed to all outputs (NMEAx2, WiFi
and USB). Data can be routed to limit the data flow to only certain output/s by un-ticking the
corresponding boxes in the Configuration software.
NMEA Baud rates:
Default Baud rates are set to:
NMEA IN 1 and 2: 4800bps
NMEA IN 3: 38400bps
NMEA OUT 1: 4800bps
NMEA OUT 2: 38400bps
These can be changed as required.
USB input:
The USB connection is 2 way as standard, no additional configuration required. Man-
ual NMEA input via USB is also possible through the configuration software. A good understand-
ing of NMEA sentence structure is required for this additional function.
SET-UP GUIDE
QK-A033
WIFI/USB/NMEA 0183 MULTIPLEXER
WITH SEATALK™ CONVERTER
All products are CE, RoHS certified
More information at www.quark-elec.com
Please recycle your packaging
