EN 12
3139 785 31681
4.
Mechanical Instructions
2) Service position for Digital Board is given in Figure
4-10.
Figure 4-10: Digital Board Service Position
4.5
Dismantling of the DTTM, HDMI, IR Blaster
and
Analog
Boards
1) Remove 4 screws and 3 catches the HDMI board (1x)
and DTTM board (2x) as shown in Figure 4-11.
Figure 4-11
2) Remove 8 screws to loosen the Analog Board (3x) and
IR Blaster board (2x) + bracket 193 assembly (3x) as
shown in Figure 4.12.
Figure 4-12
3) Remove 9 screws on the Rear Panel to remove the
Analog Board as shown in Figure 4.13.
Note:
It may be necessary to loosen the Digital Board
because the cable from the Front Panel is sandwiched
between the Digital and Analog Boards.
Figure 4-13
Insulation Sheet
