EN 104
3139 785 31681
Firmware Upgrading & Diagnostic Software
5.
Note
European sets only!!
Nucleus Name
DS_FRE_CommunicationIfModule
Nucleus Number
2003
Description
This nucleus checks the communication with the IF(Intermediate Frequency)
module of the front end
Technical
-
Determine whether the IF module can be read through IIC
Execution Time
Less than 1 second
User Input
<Tuner>
Tuner: Select the tuner type that you want to tune. This input is not mandatory.
(If no input is detected, tuner will be defined run-time (if recognised).)
Tuner Tuner
ID
Runtime
Detected
1 FE1316
(Europe
Philips) V
2 FE1319
(Europe
Philips) V
3
TMQZ2-403A (Europe ALPS)
Error Number
Description
200300
Communicating with the front end succeeded
200301
The IIC bus was not accessible
200302
There was a timeout reading the device
200303
The IIC acknowledge was not received
200304
An IIC-bus error occurred
200305
Got unknown IIC bus error
200306
The IIC bus initialisation failed
200307
Not a Europe set
Example
DS:> 2003 3
200300:
Test OK @
Hard Disk Drive (HDD)
Nucleus Name
DS_HDD_Communication
Nucleus Number
2100
Description
Check the communication between the digital board and the hard disk drive by
querying the device type of the hard disk drive
Technical
-
Initialise/start IDE
-
Check for an ATA device on the IDE interface
Execution Time
3 seconds
User Input
None
Error Number
Description
210000
Communication with the hard disk drive succeeded
210001
The initialisation of IDE failed
210002
Communication with the hard disk drive failed
Example
DS:> 2100
210000: Found a hard disk drive: MASTER device on IDE interface 1
Test OK @
Nucleus Name
DS_HDD_Reset
Nucleus Number
2101
Description
Reset the hard disk drive
Technical
-
Initialise/start IDE
-
Check for an ATA device on the IDE interface
-
Toggle the IDE reset pin of the selected interface
Execution Time
1 second
User Input
None
Error
210100
Resetting the hard disk drive succeeded
210101
The initialisation of IDE failed
210102
Communication with the hard disk drive failed
210103
Failed to reset the hard disk drive
Example
DS:> 2101
210100: Resetting IDE interface 1 succeeded
Test OK @