Operations Manual
2 6
CONSOLE ADVANCED OPERATION
• Use
SOFTKEY D
to select the fixture that you want. The LCD screen will change to allow you to set the start
address for the fixture you have selected.
Figure 24: ML Starting Address - LCD Display
It is possible to change the DMX address using the FX 1 through FX 10 keys. (FX10 is 0).
The Flash buttons that have no fixture assigned to them will be flashing. Press a Flash button to assign a fixture to it.
It is possible to assign more than one fixture at the same time. If you wish to assign 4 fixtures of the same type, press
and hold the flash button where you wish to store the first one. Then press and the flash button 4 along. You will now
have patched 4 fixtures of the same type.
Note:
The 200 Plus will not allow you to over-patch fixtures. You will get a warning if you try and do this.
Repeat these steps until you have patched all the fixtures you have. When you have completed this process press
Menu to leave the set up functions.
Note:
To create a new or your own fixture library, see
"CREATING MOVING LIGHT (ML) AND LED FIXTURE
LIBRARIES" on page 70
.
Using your Moving Lights
Now that the moving lights are patched, the
Preset A
faders are used to set the intensity of the fixtures. The
Preset
A Flash
buttons are used to select fixtures. Once a fixture is selected it is possible to adjust its various parameters.
The monitor display will provide you with information about the moving lights and their attributes as shown in
Figure 25 on page 27
.
Menu
Release
DMX Base
FX
A
B
C
D
Other
Fix
Exit
Pat. ELA36LTB1
to DMX [215]
Press Bump
Button To Patch
Master: xxx
Fixture Patch