Peregrine Systems DPND-523-EN12, Setup Manual

Page: 71 / 170

Log in to Network Discovery | 71
Setup Guide
Note: Account names are all lowercase.
Passwords are case-sensitive. “PASSWORD” and “password” are two
different passwords.
„
Once the account name and password are accepted, the Network
Discovery Home page and Toolbar appear.
„
After the Toolbar appears, but before it is activated for use, your browser
will display one or more security warnings. You are asked to grant
Network Discovery permission to run.
4 Click the check box next to “Always trust content from Peregrine Systems,
Inc.” and click
Yes .
Note: The security warning will differ depending on the browser you are using.
Note: This should be the only time you use the default password for the “admin”
account. See
Change the default Admin password on page 88 .
Troubleshooting when logging in for the first time
Why can’t I connect to Network Discovery?
„
Check that you connected the Ethernet cable to the correct Ethernet port
(see
Connect the appliance to the network on page 60 )
„
Double check that the link light on the back of the Peregrine appliance is lit.
If this light is not lit, you will not be able to connect to your Peregrine
appliance.
„
If you entered the correct URL in your browser, it is likely that the IP address,
network mask, or gateway address were not entered correctly through the
configuration interface (
Give the Peregrine appliance its network
information on page 56 ). You can go back, re-attach the keyboard and
monitor, and check the network information.
„
If the network information is correct, it may be that your management
workstation cannot reach that portion of the network to which the
Peregrine appliance is connected. It is recommended that the workstation
or laptop used as your management console be connected to the same