Peregrine Systems DPND-523-EN12, Setup Manual

Page: 55 / 170

Install Network Discovery software from the CD | 55
Setup Guide
To install Network Discovery
1 Place the Network Discovery installation disc in the CD-ROM drive of the
server and restart the server.
Note: Network Discovery will install if you have 1, 1.5, 2, 2.5, or 4GB of memory.
If you have more than 4GB, the software will not install. You must have the
exact hardware configuration as described in
Compatibility Matrix on
page 33 .
The system boots from the CD and then prompts you to enter one of two
options:
„
reformat (reformats the hard disks to factory specifications)
„
boot (reboots the system)
2 Type
reformat
and press Enter .
After the format has completed, you see the options again:
„
reformat
„
boot
3 Type
boot
and press Enter to restart the system.
During the reboot, the installation CD detects that the hard drives are
formatted correctly and installs the packages required for Network
Discovery. After the packages have been installed, the CD ejects, and the
server reboots.
4 Remove the CD and store it in a safe place.
Network Discovery is installed on the server and you now have a Peregrine
appliance.
If you see an error message telling you that there is a problem with the
hardware, contact Peregrine Systems Customer Support.