GRL-PCIE5-CEM-RXA User Guide and MOI
Rev7.0
© Granite River Labs 2022 Version 7.0, June 2022. Updated 06.29.2022
Page 32 of 123
By default, the calibration target values are those defined in the specification. To change the
values, un-select the
‘
Use Default Value
’
checkbox. In case the default values are required again,
just select the checkbox to allow all existing values to be reset to default.
Note: The PID Control setting is used to adjust the step width for steps calculation if the target
measurement cannot be met with the current step. To adjust, use a lower PID Control value to
reduce the subsequent step or increase the control value to make the subsequent step bigger.
F
IGURE
22.
C
ALIBRATION
T
ARGET
O
VERWRITE
P
AGE
4.8
Run Automation Calibration
Once calibration have been selected and set up from the previous sections, the calibration are
now ready to be run.
Select
from the menu to access the Run Tests page. The GRL-PCIE5-CEM-RXA software
automatically runs the selected calibration when initiated.
Before running the calibration, select the option to:
•
Skip Test if Result Exists
‒ If
results from previous calibration exist, the software will
skip
those calibration.
•
Replace if Result Exists
‒ If results from previous
calibration exist, the software will
replace
those calibration with new results.
