7 • Ethernet
Model 6511RC Matrix Switch Administrators’ Reference Guide
50
Ethernet Configuration window
Ethernet Configuration window
The Ethernet Configuration window (see
figure 26
) allows you to make changes to the Ethernet configuration.
To reach this window, select Modify Parameters… from the Ethernet Overview main window.
Figure 26. Ethernet Configuration window
State (boxEtherAState)
Indicates the state of the Ethernet interface. The following states are valid:
•
notInstalled(0)—Ethernet interface is not physically present
•
noLinkIndication(1)—no cable is connected to Ethernet interface. Hub is not seen.
•
adminOff(2)—Ethernet interface has been turned off by setting technique to disable
•
linkIndication10M(3)—Ethernet is 10M
•
linkIndication10Duplex(4)—Ethernet is 10M full duplex
•
linkIndication100M(5)—Ethernet is 100M
•
linkIndication100Duplex(6)—Ethernet is 100M full duplex
PrimaryIPAddress (boxEtherAPrimaryIpAddress)
The primary Ethernet IP address.
PrimaryIpMask (boxEtherAPrimaryIpMask)
The primary Ethernet IP subnet mask.
PrimaryIpFilters (boxEtherAPrimaryIpFilters)
Filters packets based on the filters assigned to the Primary IP address of the Ethernet port. Enter the Filter ID
of a filter configured under Filter IP. Use a comma (,) to separate multiple filters.
Summary of Contents for 6511RC
