Parker 590+ series, Product Manual

Page: 35 / 545

Installing the Drive
3-1
DC590+ Series DC Digital Drive
Mechanical Installation
IMPORTANT Read Appendix B: “Certification" before installing this unit. Refer to “
22H
Installation Drawings”, page
23H
3-75 for further
information. Note the additional information for Frame 6 and Frame H at the end of this Chapter.
Unpacking the Drive
Caution
The packaging is combustible and this action may produce lethal
toxic fumes.
Save the packaging in case of return. Improper packaging can result in transit
damage.
Frame H Packaging
Large drives (Frame H) are supplied in special packaging bolted to a pallet
with removable sides. Remove all fixings from the pallet.
Figure 3- 1 Lifting Details (Frame H)
Lifting the Drive
Use a safe and suitable lifting procedure when moving the drive. Never lift the drive by its terminal connections. Prepare a clear, flat surface to receive
the drive before attempting to move it. Do not damage any terminal connections when putting the drive down.
Frame 4 & 5 drives have lifting eyes and a shipping plate fitted to the base to enable the drive to be lifted into position, or to be set-on-end by a forklift.
Remove the shipping plate before wiring the power terminals.
Frame H drives require the following:
•
The drive is supplied with a lifting bracket fitted to each corner for hoisting. Remove the brackets when the drive is in its final position, however,
the bracket fixings MUST be re-fitted. Refer to Appendix E: “Technical Specifications” - Termination Tightening Torques (Frame H).
•
A shipping plate is fitted to the base to enable the drive to be set-on-end by a forklift. Remove the plate before wiring the power terminals.