Parker 590+ series, Product Manual, Page: 137 / 545

Operating the Drive
4-5
DC590+ Series DC Digital Drive
Setting-up the Drive
IMPORTANT You must not exceed the maximum drive and motor ratings. Refer to the Product Code or maximum rating label, and the
motor rating plate.
The following start-up routine assumes that the Keypad is connected and is in default mode, and that the Drive’s control terminals are wired as shown
in the Minimum Connection diagrams in Chapter 3.
The following instructions are written in logical order. Complete each stage successfully before progressing to the next.
Calibrating the Control Board
AUXILIARY POWER ONLY IS CONNECTED AT THIS STAGE
You must first calibrate the Drive for use with the motor.
Connect the auxiliary power supply to auxiliary supply terminals L & N (Frame 3: Terminals L & N = D8 & D7), but
do not connect the main 3-phase power supply at this stage. Check that the correct voltage appears between these
terminals.
The Keypad will now display the Welcome screen, and the Health and Forward LEDs will be illuminated (assuming
that the Drive’s control terminals are
wired as shown in Figure 3-4,
Minimum Connection
Requirements).
NOTE The CONFIGURE DRIVE menu
at the top of the menu tree
contains many of the important
parameters used during set-up.
Refer to Chapter 6: “The Keypad”
to familiarise yourself with the
keypad’s LED indications, and
how to use the keys and menu
structure.