Chapter 4
Settings — [PROJECTOR SETUP] menu
164 - ENGLISH
12) Adjust [LIGHT OUTPUT] of each projector.
f
Adjust [LIGHT OUTPUT] of all the other projectors so that the brightness will be the same as the projector
with the least brightness.
13) Set [CONSTANT MODE] of [BRIGHTNESS CONTROL SETUP] to [AUTO], and [LINK] to [GROUP A] in
all projectors.
14) Select [APPLY] of [BRIGHTNESS CONTROL SETUP] and press the <ENTER> button in all projectors.
f
Brightness control starts.
Note
f
Brightness is automatically corrected whenever the light source lights up by switching on/off the projector, etc.
f
When the variation in brightness has increased due to aging of the light source, or when you replaced the light source, readjust the
brightness control.
[STANDBY MODE]
Set the power consumption during the standby.
1) Press
as
to select [STANDBY MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL]
Select this item to use the network function during standby.
[ECO]
Select this item to reduce power consumption during standby.
Note
f
The AC voltage monitor function, the network function, the <SERIAL OUT> terminal, and part of the RS-232C command cannot be used
during the standby when set to [ECO].
When an error or warning occurs on the projector, the self-diagnosis display appears on the control panel regardless of the [STANDBY
f
When [ECO] is set, it may take approximately 10 seconds longer before the projector starts projecting after the power is turned on,
compared with when [NORMAL] is set.
f
When [NORMAL] is set, the network function and the <SERIAL OUT> terminal can be used during standby.
f
When [NORMAL] is set, power can be supplied by using the <DC OUT 1> terminal or the <DC OUT 2> terminal even while the projector is
in standby mode. If [ECO] is set, power cannot be supplied in standby mode.
f
The [STANDBY MODE] setting does not return to factory default setting even if the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[ALL
USER DATA] is executed.
[NO SIGNAL SHUT-OFF]
A function that automatically switches the power source of the projector to standby if there is no input signal for a
certain period of time. The time before switching to standby can be set.
1) Press
as
to select [NO SIGNAL SHUT-OFF].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DISABLE]
Disables the No signal shut-off function.
[10MIN.] - [90MIN.]
Sets the time in increments of 10 minutes.
[NO SIGNAL LIGHTS-OUT]
This is a function to automatically turn off the light source of the projector when there is no input signal for specific
period. The time until the light source is turned off can be set.
1) Press
as
to select [NO SIGNAL LIGHTS-OUT].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DISABLE]
Disables the no signal lights-out function.
[10SEC.] - [5MIN.]
Turns off the light source when there is no input signal for the preset period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.], or [5MIN.].
