Chapter 2
Getting Started — Attaching/removing the projection lens (optional)
ENGLISH - 49
Attaching/removing the projection lens (optional)
Move the projection lens to the home position before replacing or removing the projection lens. (
Attention
f
Replace the projection lens after turning off the power of the projector.
f
Do not touch the electric contacts of the projection lens. Dust or dirt may cause poor contact.
f
Do not touch the surface of the projection lens with your bare hands.
f
Before attaching the projection lens, remove the lens cover attached to the projection lens.
f
lens removed. Touching around the projection lens mount inside the projector may result in malfunction.
f
Do not install the Fixed-focus Lens (Model No.: ET-D75LE5 (production discontinued)) on the projector. Installing by mistake will cause
malfunction of the projector.
f
Panasonic takes no responsibility for any damage or malfunction of the product resulting from the use of projection lenses which are not
manufactured by Panasonic. Be sure to use the specified projection lenses.
Note
f
The precautions for handling the lens are different for the Fixed-focus Lens (Model No.: ET-D75LE95, ET-D75LE90). For details, refer to the
Operating Instructions of ET-D75LE95 or ET-D75LE90.
Attaching the projection lens
Attach the projection lens using the following procedure. Start from Step
when the lens hole cover is already
removed.
Mark (orange)
Fig. 3
Fig. 4
Fig. 1
Fig. 2
Screw hole A
Lens fixing screw
Screw
Lens hole cover
Lens release button
1) Loosen the screw fixing the lens hole cover. (Fig. 1)
f
Use a Phillips screwdriver to turn the screw fixing the lens hole cover counterclockwise until it turns freely.
