Chapter 7
Appendix — Installing the Interface Board (optional)
ENGLISH - 281
Installing the Interface Board (optional)
This projector is equipped with two SLOT NX-specification slots.
There are four SDI input terminals and one DIGITAL LINK input terminal equipped on this projector as the
standard video input terminals. The input for HDMI, DVI-D, and SDI can be added by installing the optional
Interface Board in the slot.
Requesting a qualified technician to install or remove the optional Interface Board is recommended. A malfunction
may occur due to static electricity. Consult your dealer.
Before installing or removing
f
Always turn off the power of the projector before installing or removing the Interface Board.
g
Always follow the procedure of “Switching off the projector” (
page 71) when turning off the power.
f
Do not touch the connector section of the Interface Board directly with your hands.
g
The component may be damaged by the static electricity.
f
Remove the static electricity from your body by touching to surrounding metal, etc., in advance to prevent the
static electricity damage.
f
Take care not to get injured when installing or removing the Interface Board.
g
Hands may be injured by the opening of the blank slot or the edge of the bracket of the Interface Board.
f
When installing the Interface Board to the slot, insert it into the connector straight and slowly.
g
It may not operate or cause malfunction if it is not correctly installed.
f
To use the 3G-SDI Terminal Board with Audio (Model No.: TY-TBN03G), it is necessary for the firmware version
of the 3G-SDI Terminal Board with Audio to be 2.00 or later. Consult your dealer regarding the version update to
the latest firmware if the version is earlier than 2.00.
f
The figure indicating the installation and removal of the Interface Board is using the Interface Board for HDMI 2
input (Model No.: ET-MDNHM10) as an example.
How to install the Interface Board
Screws (4 locations)
Screws (4 locations)
Salient
Guide groove
Slot cover
Fig. 1
Fig. 2
Fig. 3
1) Remove the slot cover. (Fig. 1)
f
Remove the four screws fixing the slot cover by rotating counterclockwise with a Phillips screwdriver. The
removed screws are used to fix the Interface Board.
f
When removing the fourth screw, hold the slot cover with your hand so it will not fall.
f
To replace from other Interface Board, remove the Interface Board following the procedure in “How to
2) Install the Interface Board to the projector. (Fig. 2)
f
Insert the guide groove of the Interface Board aligned to the salient of the slot. Insert the bracket firmly all
the way in.
3) Fix the Interface Board. (Fig. 3)
f
Tighten and fix with the four screws removed in Step
