Chapter 4
Settings — [PROJECTOR SETUP] menu
92 - ENGLISH
3) Press
as
to select [VOLUME].
4) Press
qw
to adjust the level.
Operation
Adjustment
Range
Press the
w
button.
Increases the volume.
0 ~ 63
Press the
q
button.
Decreases the volume.
Adjusting the left to right audio balance
1) Press
as
to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The
[AUDIO SETTING]
screen is displayed.
3) Press
as
to select [BALANCE].
4) Press
qw
to adjust the level.
Operation
Adjustment
Range of adjustment
Press the
w
button.
Increases the volume on the right.
L16 ~ R16
Press the
q
button.
Increases the volume on the left.
Setting audio output of the built-in speaker
1) Press
as
to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The
[AUDIO SETTING]
screen is displayed.
3) Press
as
to select [BUILT-IN SP].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ON]
Audio is output from the built-in speaker.
[OFF]
Audio is not output from the built-in speaker.
Note
f
Audio is output from the built-in speaker even if the cable is connected to the <VARIABLE AUDIO OUT> terminal. To output audio from
external audio devices connected to the <VARIABLE AUDIO OUT> terminal and not from the built-in speaker, set [BUILT-IN SP] to [OFF].
Setting the audio output during standby
1) Press
as
to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The
[AUDIO SETTING]
screen is displayed.
3) Press
as
to select [IN STANDBY MODE].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables audio output in the standby mode.
[ON]
Enables audio output in the standby mode when [STANDBY MODE] is set to [NORMAL]. At this
time, press the <VOL-> button/<VOL+> button on the remote control or the control panel to adjust
the volume.
Note
f
When [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] (
x
page 89), even if [IN STANDBY MODE] is set to [ON], audio
cannot be output during standby.
f
When [IN STANDBY MODE] is set to [ON] and the digital signal is input, the audio output is interrupted during the cooling period after the
power is turned off, but this is not a malfunction.
