Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 87
[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-
menu.
Refer to “Navigating through the menu” (
x
page 57) for the operation of the menu screen.
[STATUS]
Display the status of the projector.
1) Press
as
to select [STATUS].
2) Press the <ENTER> button.
f
The
[STATUS]
screen is displayed.
[SIGNAL]
[NAME]
Displays the name of input signal.
[FREQUENCY]
Displays the scanning frequency of input signal.
[RUNTIME]
*
1
[PROJECTOR]
Displays the current usage time of projector.
[LAMP (ET-LAEF100*
2
)]
Displays the model No. of the replacement lamp unit for this projector.
[ECO]
Displays the lamp runtime when [LAMP POWER] is set to [ECO] by
actual time.
[NORMAL]
Displays the lamp runtime when [LAMP POWER] is set to [NORMAL] by
actual time.
[SERIAL NUMBER]
[PROJECTOR]
Displays the serial number of the projector.
*1 The following conversion is required to calculate the rough estimate for lamp replacement.
Formula for lamp replacement time (rough estimate)
A × 1 + B × 3/4
f
A : Runtime which is displayed in [STATUS] screen → [RUNTIME] → [LAMP] → [NORMAL]
f
B : Runtime which is displayed in [STATUS] screen → [RUNTIME] → [LAMP] → [ECO]
*2 The model No. of the optional lamp unit is subject to change without prior notice.
Note
f
The “RUNTIME” displayed in the [STATUS] may be different from the actual times when a lamp unit that was attached to a different projector
model is installed on this projector (PT-FZ570, PT-FW530, PT-FX500), or when the lamp unit that was attached to this projector is installed
on a different projector model.
f
The [SIGNAL] is shown in gray and the values are blank for [NETWORK] input.
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1) Press
as
to select [PROJECTOR ID].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ALL]
Select this item to control projectors without specifying an ID number.
[1] ~ [64]
Select this item when specifying an ID number to control individual projector.
Note
f
To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f
When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
If multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f
Refer to “Setting the ID number of the remote control” (
Æ
page 55) for how to set the ID number on the remote control.
[INITIAL START UP]
Set the method of start up when the power cord plugged into the AC outlet.
1) Press
as
to select [INITIAL START UP].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
