Chapter 4
Settings — [NETWORK] menu
102 - ENGLISH
[SIGNAL QUALITY]
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
f
MAX/MIN: Maximum/minimum value of the amount of error.
f
Green (-12 dB or lower)
→
Normal signal quality level.
f
Yellow (-11 to -8 dB)
→
Warning level where there is the possibility of noise introduced on the
screen.
f
Red (-7 dB or higher)
→
Abnormal level where synchronization may be interrupted or a signal may
not be received.
[DIGITAL LINK MENU]
When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected
to the <DIGITAL LINK/LAN> terminal, the main menu of DIGITAL LINK output supported device is displayed.
Refer to the Operating Instructions of the DIGITAL LINK output supported device for details.
Note
f
When [NETWORK] menu → [NETWORK CONTROL] → [EXTRON XTP] is set to [ON], [DIGITAL LINK MENU] cannot be selected.
[WIRED LAN]
You can make detailed wired LAN settings.
1) Press
as
to select [WIRED LAN].
2) Press the <ENTER> button.
f
The
[WIRED DETAILED SETUP]
screen is displayed.
3) Press
as
to select an item, and change the setting according to the instructions.
[DHCP]
[ON]
If a DHCP server exists in the network to which the
projector is connected, the IP address will automatically be
acquired.
[OFF]
If a DHCP server does not exist in the network to which
the projector is connected, additionally set [IP ADDRESS],
[SUBNET MASK] and [DEFAULT GATEWAY].
[IP ADDRESS]
Enter the IP address if DHCP server is not used.
[SUBNET MASK]
Enter the subnet mask if DHCP server is not used.
[DEFAULT GATEWAY]
Enter the gateway address if DHCP server is not used.
[DNS1]
Enter the preferred DNS server address if DHCP server is not used.
[DNS2]
Enter the alternate DNS server address if DHCP server is not used.
4) Press
as
to select [OK], and press the <ENTER> button.
r
Default settings of [WIRED LAN]
f
The following settings are set before the projector leaves the factory.
[DHCP]
OFF
[IP ADDRESS]
192.168.10.100
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.168.10.1
[DNS1]/[DNS2]
NONE
Note
f
Before using the DHCP server, make sure the DHCP server is already functioning.
f
Consult your network administrator regarding the IP ADDRESS, SUBNET MASK and DEFAULT GATEWAY.
f
The settings of network are same for both the <LAN> terminal and the <DIGITAL LINK/LAN> terminal.
[PROJECTOR NAME]
Change the name as desired in such a case as the projector needs to be identified on application software.
1) Press
as
to select [PROJECTOR NAME].
