Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 89
5) Press
as
to select [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] or [AV MUTE DETECTION].
[AMBIENT LIGHT
DETECTION]
Adjusts the power of the lamp according to the brightness of the installation location.
[SIGNAL DETECTION]
Lowers the power of the lamp when there is no signal.
[AV MUTE DETECTION]
Lowers the power of the lamp when the [AV MUTE] is [ON].
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ON]
Enables the setting.
[OFF]
Disables the setting.
Note
f
Lamp power cannot be reduced automatically in the following cases:
- When the lamp lighting is just completed or the setting of [LAMP POWER] is just completed, etc..
f
When [AUTO POWER SAVE] is set to [OFF], settings of [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTE
DETECTION] are unavailable.
f
When [LAMP POWER] is set to [ECO], settings of [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTE DETECTION]
are unavailable.
f
When objects, etc. are placed around the luminance sensor on the top of the projector, [AMBIENT LIGHT DETECTION] may not function
properly.
Setting [POWER MANAGEMENT]
Set the operation as following if there is no signal input.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The
[ECO MANAGEMENT]
screen is displayed.
3) Press
as
to select [POWER MANAGEMENT].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[SHUT DOWN]
The countdown timer is displayed after 30 seconds without input signal. The projection lamp is turned
off and cooled down when reached the set time, then the projector enter into standby status.
[OFF]
Power management function is off.
[READY]
The countdown timer is displayed after 30 seconds without input signal. The projection lamp turns off
and cools down when reaching the set time, meanwhile the projector is in the power management
mode. The projection lamp will be turned on if the input signal is reconnected or any button is pressed.
Setting [TIMER]
The timer can be set to 5-120 minutes. The increment is 5 minutes.
1) Press
as
to select [TIMER].
2) Press
qw
to set the timer.
f
The time will switch each time you press the button.
Setting [STANDBY MODE]
Set the power consumption during standby.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The
[ECO MANAGEMENT]
screen is displayed.
3) Press
as
to select [STANDBY MODE].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL]
Select this item to use the network function or the serial communication function during standby.
