Panasonic LP-400 Series, External Control Manual

Page: 66 / 180

66
⿎ Control sample 1-2: Changing the marking characters for each marking
“READY”: OFF
1. Laser pumping (ON) LSR command
Remote mode ON
Remote mode OFF
2. Select file No. FNO command
3. Shutter setting (open) SHT command
4. Serial data input SIN command
5. Status request STS command
6. Marking trigger MRK command
7. Serial data input SIN command
8. Shutter setting (close) SHT command
9. Laser pumping (OFF) LSR command
* “READY” will turn ON after the SIN command reception.
* Before sending SIN data, keep 20 sec. (LP-V series) or 15 sec. (LP-400 / LP-W series)
after turning ON the laser pumping, and 1 sec. after the opening shutter.
Send STS command
again after a while.
Select the file in that Serial data marking function is set.
“READY”: ON
Yes
To finish the
marking
Change the character.
No.
Send the character data to be marked.
Reference
• For using this command, set “serial data” of function characters at setting screen beforehand.
• When using this function (serial data), transmit this command by every marking. Otherwise it does not become marking
ready condition, and marking is not available.
• Only when the internal shutter is opened during the remote mode, the serial data can be transmitted to the laser marker.
• When transmit this command without any data, marking ready become ON, then nothing to be marked with serial data
input.
• For resetting the data, set the “reception mode ON” for command reception permission (MKM command) or close the
shutter.
ME-LP400V-EX-6