Panasonic LP-400 Series, External Control Manual

Page: 156 / 180

156
ERROR
CODE
Error details Measures
E640 Invalid function for combining with flying object.
• With the marking to flying object, do not use the
following functions.
• Step & repeat
• Reset at date update function
• Arbitrary point radiation
• Overwrite function
• With the equidistant marking to flying object, do
not use the following functions.
• Rank
• External offset
• Serial data marking
• Release flying object marking function with trigger
setting.
E650 Invalid setting of processing element.
Set the distance between start and end points of the
arc smaller than double of radius.
E651 Too short line segment of processing element.
Set the larger value to the length of the line than
width of the line.
E660 Cannot convert dxf file.
• Save the DXF file with DXF-R12J, R13J or R14
format.
• Delete the entities which are not supported by
laser marker in the DXF file.
• Read the DXF file again to the laser marker.
E690 Cannot finish measurement during specified time.
• Reduce marking contents and measure marking
time.
• Speed up scan speed.
E700 Unable to lase as laser pumping is turned OFF.
Turn ON the laser pumping and after the laser
pumping has completed, start marking.
E701
*1
Started laser power check in laser pumping OFF
state. Turn ON the laser pumping and after the laser
pumping has completed, start power check.
E800
---------------------------
(no message : Invalid input of marking trigger while
Ready is OFF.)
• Change marking timing so that trigger input is
performed after marking ready output is turned on.
• Check wiring and control procedure for I/O
terminal, wiring to communication port, and the
procedure of the communication command.
E811 Occurred laser stop from external terminal.
• Check the wiring of the laser stop input terminal
and contact of the switch.
• Confirm operation logic of connection device.
E900
Existed invalid function character for simultaneous
use.
The following combination of the functions are not
available in one file.
• Serial data marking function and rank function
• Serial data marking function and external offset
function
Delete any one of these functions from the file.
E901 Existed invalid character for converting into 2D code. Set the character that can be converted into 2D code.
E902 Cannot create 2D code. Use the condition where 2D code can be created.
*1 : Error that may occur for LP-V / LP-W series only.
ME-LP400V-EX-6