Panasonic KX-TDA50, Features Manual, Page: 130 / 668

1.16 Caller ID Features
130 Feature Guide
[Programming Example: System Speed Dialing Table]
4.
Displaying the Caller's Name
In addition to the System Speed Dialing Table, each extension can store names and numbers in
Personal Speed Dialing. Therefore, it is entirely possible for the same telephone number to be stored
under a different name in different locations within the PBX.
When a call containing Caller ID information is received, the PBX will search for the caller's name in the
following order, then show that name on the display and log it via SMDR.
1)
Personal Speed Dialing data of the extension which received the call
2)
System Speed Dialing Table
3)
The Caller ID information received from the telephone company
If a caller's name is not stored in the PBX or sent from the telephone company, it will not be displayed
or logged.
Conditions
[General]
• Caller ID signaling type can be selected through system programming (
→
Caller ID Signal Type [490]).
[Caller ID to SLT Port]
• Hardware Requirement: An EXT-CID card.
• Through system programming, a group of 4 SLT or Super Hybrid ports can be assigned to receive
Caller ID information. Up to 2 groups can be programmed. Therefore, a maximum of 8 SLTs can receive
Caller ID information.
• When the caller's telephone number is sent to an SLT, a CO Line Access number can be automatically
added to the telephone number through system programming.
• If the caller's telephone number exceeds 16 digits, the SLT receives only the first 16 digits, not counting
the preceding CO Line Access number (if it is programmed to be added).
• If a call is transferred to an SLT, the transferring extension's information will be shown on the SLT. If the
transferring extension goes on-hook before the call is answered, the original caller's information will be
shown.
• When Caller ID information such as "Private", "Out of Area", or "Long Distance" is received, this
information will be shown instead of the caller's number and name.
• If an SLT is connected to a DPT in parallel, Caller ID information will be shown on the SLT only if the
SLT is set to "ring".
• Depending on the type of SLT being used, caller names may not be able to be displayed.
• Incoming Call Log information is not shown on the SLT.
*1
→
System Speed Dialing Name [002]
*2
→
System Speed Dialing Number [001]
Location
(System Speed
Dialing No.)
000
001
System Speed
Dialing Name
*1
ABC Company
XYZ Company
Telephone No.
*2
912125551234
913135551234
CLI Destination
200
300