2.6 Help
PC Programming Manual
71
Portable Stations
A
•
Is the card installed in the appropriate slot?
•
Is the card installed in the correct slot, but not functioning correctly?
Check the condition of the card.
•
Is the card itself in INS status?
Set it to INS status.
•
Is a CO line line connected to the appropriate port?
•
Is the port in FAULT status, even though a CO line is connected?
Run diagnosis on the relevant slot.
Q
How do I prevent newly installed cards automatically being changed to "INS"?
A
•
Change
New Card Installation—Card Status for any Card
in
2.7.32 [1-3] Option
from
"In Service (INS)" to "Out of Service (OUS)".
Q
I cannot register Portable Stations using the method described in Portable
Station [1-2].
A
•
Is the status of the CSIF, DHLC or DLC card set to "INS"?
•
Is a CS connected to the CSIF, DHLC or DLC card? If not, connect one.
•
Do the PINs (Personal Identification Numbers) of the PBX and the Portable Station
match? Confirm that they are the same.
•
Is the Portable Station within transmission range of the CS?
•
Has the Portable Station previously been registered at another location?
It is not possible to register a Portable Station at 2 locations, so use the
Forced De-
registration
option to delete the previous registration.
Q
I cannot delete the extension number of a Portable Station.
A
•
First, de-register the Portable Station itself, and then delete the extension number.
Q
I cannot de-register a Portable Station.
A
•
Is the Portable Station turned on? If not, turn it on.
•
Is the Portable Station within transmission range of the CS? If not, move it closer to the
CS and try the de-registration operation again.
Q
The Portable Station I want to de-register is broken, and will not turn on, or is
not available, or the registration information was deleted first from the Portable
Station, so it cannot be de-registered.
A
•
The Portable Station can be forcibly de-registered by the following the procedure shown
in
Forced De-registration
of
2.7.31 [1-2] Portable Station
.
Q
I changed the extension number of a Portable Station, but the display of the
Portable Station still shows the old extension number.
A
•
Turn the Portable Station off and back on again, to force it to re-register its location.
Q
I changed the FCO of a Portable Station, but the display of the Portable Station
still shows the old FCO.
A
•
Turn the Portable Station off and back on again, to force it to re-register its location.
