Panasonic FP10S, Technical Manual

Page: 39 / 152

FP3 MEWNET - TR
Chapter3 - 1. Page.37
33
2. Slave Station
1) Installation environment
J Slave station installation space
50 mm/1.969 in.
or more
100 mm/3.937 in.
or more
Slave station
(FP I/O transmitter unit
or expansion FP I/O
terminal unit)
50 mm/1.969 in.
or more
Other
devices
Panel
Wiring duct
Wiring duct
FP I/O transmitter unit
Expansion
FP I/O terminal unit
x
Leave at least 50 mm/1.969 in. of space between ducts and other devices to avoid heat radiation.
x
When installing devices facing the slave station, such as those on the panel, leave at least 100 mm/3.937 in. of space
between the devices and the slave station to avoid heat and noise radiation.
x
The FP I/O transmitter unit can be installed in any direction.
J Notes on installation
x
The slave station should be used under the following conditions.
- At ambient temperatures of 0
q
C to 55
q
C (32
q
F to 131
q
F)
- At ambient humidity of 35 % to 85 % RH
x
Do not use the slave station in places where it will be subject to:
- Sudden temperature changes causing condensation
- Inflammable or corrosive gas
- Excessive airborne dust or iron particles
- Benzine, paint thinner, alcohol, other organic solvents, or strong alkaline solutions of ammonia or caustic soda
- Excessive vibration or shock
- Direct sunlight
- Water splashes
- Influence from power transmission lines, high-voltage equipment, power cables, power equipment, radio
transmitters, or any other equipment that generates high switching surges
x
Do not drop the unit or apply excessive force to it.
x
Do not install the unit above devices that generate large amounts of heat such as heaters, transformers or power resistors.
3 -1. Installation