Panasonic FP-7818, Service Manual & Parts Manual

Page: 141 / 402

6-4
Location Shipping material/Procedure Check
5
Magnet
brush
Shield plate
Mag-roller Mag-roller
gear
Pour the developer into the unit
(1) Remove the developer unit lid.
(2) Pour the developer evenly into the
unit.
Note: Pour in the entire bottle of
developer, after shaking it well.
(3) Reinstall the developer unit lid.
(4)-1. Rotate the mag-roller gear clockwise
(down-ward) several turns in order to
distribute developer evenly on the
sleeve.
(4)-2. Rotate the mag-roller gear counter-
clockwise (up-ward) about 90 degrees
in order to form magnet brush between
shield plate and sleeve.
(4)-3. Rotate the mag-roller gear clockwise
(down-ward) several turns again to
stabilize magnet brush.
(5) Reinstall the developer unit.
(6) Reconnect the TDC connector.
(7) Reinstall the drum unit.
(8) Pull the developer unit release lever
out until it stops and rotate it 90
degrees counterclockwise.
(9) Push the developer unit release lever
back in until it stops.
Cleaning blade pressure release
(1) Install the cleaning blade pressure
spring to the pin.
(2) Reconnect the solenoid connector.
(3) Reinstall the solenoid cover. (1 screw)
(4) Swing back the toner bottle/hopper.
(5) Raise the paper transport.
(6) Close the front cover.
(7) Install the waste toner bottle.
(8) Close the waste toner bottle cover.
Note: P l e a s e t a k e c a r e f o r
Tonerrecycle Solenoid
Harness, if you push in the
drum unit.
6
Pin
Spring