ELC500 Control unit
137
Item
Description
(a) No.
Selected registered number is displayed. (Max. 16)
(b) Trigger
Set trigger to send mail.
Main unit trigger: Select trigger No, from registered triggers.
Status change: Designate ELC500 status change.
Ladder command: Designate program command by FPWIN Pro7.
(c)
Trigger No./
Condition *1
Set trigger.
(d) Destination
Set destination to select group to send mail.
(e) Title
Set title of sending mail. If not set, it can’t register.
<Set range> 64-letter or less
(f)
Body
Set body to send.
<Set range> 256-letter or less
*1 Operating conditions for status change
Power on: When Power on ELC500
Mode change (STOP/PROG.>RUN): When change STOP/PROG. mode to RUN mode
Mode change (RUN>STOP/PROG.): When change RON mode to STOP/PROG. mode
Operation stop self-diagnostic error detection:
When operation in error code list becomes to stop from normal
Operation continue self-diagnostic error detection:
When operation in error code list becomes to hold error from normal
Reset errors: Reset errors with status view or ERR command
- Self-diagnostic error - Unit error
- Unit verification error - Calculation error
- RTC data error - Power supply unit lifetime warning
- RTC backup battery error - SNTP time updating error
Note
- Up to 256-letter can be used for mail address in group.
Every time you add new address, it uses area for 1-letter.
Ex.) Register 1 address: up to 256-letter can be used
Register 2 addresses: up to 255-letter can be used
Register 3 addresses: up to 254-letter can be used
- In order to send mail, it is necessary to setup items related to send mail.
(a)
(b)
(c)
(d)
(e)
(f)
