61
List of Error Codes
02F5: DMA Test Failed
ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers.
02F6: Software NMI Failed
ServerBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt).
02F7: Fail - Safe Timer NMI Failed
ServerBIOS2 test error: Fail-Safe Timer takes too long.
device
address Conflict
Address conflict for specified
device
.
Allocation Error for:
device
Run ISA or EISA Configuration Utility to resolve resource conflict for the specified
device
.
Failing Bits :
nnnn
The hex number
nnnn
is a map of the bits at the RAM address which failed the memory test. Each 1 (one) in the
map indicates a failed bit. See error 230,231 or 232 for offset address of the failure in System, Extended or
Shadow memory.
Invalid System Configuration Data
Problem with NVRAM (CMOS) data.
I/O device IRQ conflict
I/O device IRQ conflict error.
Operating System not found
Operating system cannot be located on either drive A: or drive C:. Enter Setup and see if fixed disk and drive A: are
properly identified.
Parity Check 1
nnnn
Parity error found in the system bus. BIOS attempts to locate the address and display it on the screen. If it cannot
locate the address, it displays ????. Parity is a method for checking errors in binary data. A parity error indicates
that some data has been corrupted.
Parity Check 2
nnnn
Parity error found in the I/O bus. BIOS attempts to locate the address and display it on the screen. If it cannot
locate the address, it displays ????.
Press <F1> to resume, <F2> to Setup
Displayed after any recoverable error message. Press <F1> to start the boot process or <F2> to enter a Setup and
change the settings. Write down and follow the information shown on the screen.
