35
Press the eject button and slowly pull out the tray.
C e n t e r
Holder
Eject Button
Label-side up
CAUTION
Do not apply excessive force to the tray in the open position, doing so could
damage the tray.
1
Close the tray without touching the eject button.
2
3
Setting a disc
CD-ROM/DVD-ROM Drive
<CD-ROM Drive>
<DVD-ROM Drive>
Installing the device
Open the tray
Insert the disc at an angle from the front edge label-side up.
Removing the device
Place a finger on the center holder and lift up on the edge of the disc.
Close the tray
C e n t e r
Holder
Eject Button
Label-side up
2
2
Push down until the center holder clicks.
2
If the CD-ROM/DVD-ROM drive has not been accessed within 30 seconds (in the case
of CD-ROM drive), 90 seconds (in the case of CF-VDD372) or 120 seconds (in the
case of CF-VDD371), the drive motor will automatically shut down to reduce the power
consumption. When the CD-ROM/DVD-ROM drive is accessed once again, the power
of the drive motor is turned on. However, approximately 30 seconds are required until
data is actually read from the disc.
Power-saving mode
If the vibration of the CD-ROM/DVD-ROM drive is excessive, set the [CD-ROM/
DVD-ROM Drive Speed] to [Low] in the Setup Utility.
Windows NT
When a CD-ROM or a DVD-ROM is being used, the Power Management Func-
tion operates following the settings of the Setup Utility. It is possible to tempo-
rarily disable the settings by pressing
NOTE
Fn
+
F8
.
