![background image](http://html.mh-extra.com/html/panasonic/cf-29-series/cf-29-series_reference-manual_264232107.webp)
107
List of Error Codes
0613: Serial Port
*1
configuration
changed
0614: Serial Port
*1
config. error -
device disabled
*1
The port name, such as A or B,
is displayed, indicating the
conflicting ports.
I/O address and IRQ settings are in conflict.
Run the Setup Utility and change the settings in
[Advanced] menu so there is no port conflicts.
Press <F2> to Setup
Write down the error details and press
F2
to run the
Setup Utility. Confirm the settings, and change the
settings to the appropriate values as needed.
(
page 87
)
Operating System not found
The OS is not properly installed on the floppy disk or the
hard disk that you are trying to boot from.
If the computer cannot be booted from the floppy
disk, check the floppy disk drive to ensure that the
disk is in fact bootable, and change it to another if
not.
If the computer cannot be booted from the hard disk,
confirm whether the hard disk is properly recognized
in [Information] menu of the Setup Utility. (
page
89
)
• If the hard disk is recognized, perform the
reinstallation procedure.
• If not, contact Panasonic Technical Support.
If a device is connected to the USB port, disconnect
the device, or run the Setup Utility and set [Legacy
USB Support] in [Advanced] menu to [Disable].
(
page 92
)
Extended RAM Module Failed
If the extended RAM module has not been inserted
properly, or if an extended RAM module other than
one matching the specifications has been inserted, a
beep will sound and the message “Extended RAM
Module Failed” will be displayed when turning the
power on. In this case, turn the power off, confirm
that the extended RAM module meets the
specifications, and reinsert it.
Error Code/Message
Action