16
Troubleshooting the BL-WV10A
152
You cannot use Quick
Setup.
Quick Setup will work for a maximum of 8
cameras.
Is the Ethernet cable connected properly?
•
If the Ethernet cable is connected properly,
the LAN indicator will be lit green.
Quick Setup can only be performed within 20
minutes of turning on a camera that still has its
default settings (as at time of purchase).
•
Turn the camera on again.
When performing Quick Setup on the BL-C30A, is
the camera switch set to wired?
When performing Quick Setup on a computer for
cameras already initialized, is the IP address the
same as that for the BL-WV10A?
No router is displayed,
even though one is
connected.
Was the router turned on before the BL-WV10A?
•
Turn the router on and wait a minute or more
before turning the BL-WV10A on.
Is the DHCP server option in the router settings
turned off?
•
Quick Setup cannot be performed.Launch the
BL-WV10A in normal mode, and manually
perform network settings from the Setup
menu.
Display indicates no
wireless router.
This appears when the BB-HGW700A is not
connected.
•
Each device is initialized with different
wireless data settings, but can be used as is.
Are the wireless settings for the BB-HGW700A
configured to not use wireless options?
Display indicates that no
wireless router was found.
Are the wireless settings for the BB-HGW700A
configured for the 802.11a communications
mode?
•
If the BL-WV10A is used as a repeater, use a
communications mode other than 802.11a for
the BB-HGW700A. If the BL-WV10A is used
as an access point, launch in normal mode,
and then manually input the settings in the
Wireless section of the Setup menu.
Issue
Causes and Solutions
Summary of Contents for BL-WV10A
Page 179: ...179 Index...
Page 183: ...For assistance please call 1 800 272 7033 183...
