10
Adding Cameras
132
10 Adding Cameras
For BL-C10A and BL-C30A users, the camera’s firmware must be version 1.22 or
higher in order to function properly with the BL-WV10A.
For HCM series camera users, the camera’s firmware must be version 1.08 or
higher in order to function properly with the BL-WV10A.
For the latest firmware, visit http://panasonic.co.jp/pcc/products/en/netwkcam/
Refer to the Operating Instructions included with your camera for information on
confirming the firmware version of your camera.
Cameras already configured cannot use Quick Setup to become local cameras.
Reset the camera to its default settings and perform Quick Setup (see page 20). A
maximum of 8 cameras can be connected.
1.
Set the mode switch on the back on the BL-WV10A to [SETUP], turn the BL-
WV10A off and then turn it back on again.
•
When connecting to the Panasonic camera control unit, BB-HGW700A,
connect the BB-HGW700A to one of the LAN jacks on the BL-WV10A
before turning either the BB-HGW700A or the BL-WV10A on.
2.
Using the Ethernet cable that came with the camera, connect it to one of the
4 LAN jacks on the BL-WV10A and then turn the camera on.
•
When connecting a camera to the BB-HGW700A, do so after confirming
that the BB-HGW700A is already connected to the BL-WV10A.
•
Quick Setup will begin for the camera.
Ethernet cable
LAN jacks
Rear of camera
Rear panel of
BL-WV10A
Switch
Bottom of BL-C30A
To configure a BL-
C30A wireless
camera using the
Quick Setup utility,
set the switch on
the bottom of the
camera to [WIRED]
Summary of Contents for BL-WV10A
Page 179: ...179 Index...
Page 183: ...For assistance please call 1 800 272 7033 183...
