36
USB Device Mode:
USB Device Mode
A USB 2.0 connection with a PC allows you to use P2 cards
inserted in the slots on this unit as mass storage. Note that a
separate USB driver (found on the supplied CD-ROM) must
also be installed on the PC.
Use of P2 viewer, which can be downloaded from the
following site, free of charge, allows you to manipulate clips
stored on a P2 card on a Windows PC.
For details on the URL (
➝
“
Website URL
” page 2)
◆
NOTE:
• For details regarding connections, refer to the Operating
Instructions supplied with the PC and the application software.
1
Press the MODE button when this unit is idle.
2
Select USB DEVICE in the confirmation dialog and
press the SET button.
“USB DEVICE” flashes on the LCD monitor to indicate that
the unit is entering the USB host mode. After the mode
switch, “USB DEVICE DISCONNECT” appears on the LCD
monitor.
This message is replaced by a “USB DEVICE CONNECT”
message when the connection with the PC is completed.
◆
NOTE:
• Selecting 3D REC/PB or SYNC PB mode disables mode
changes until communications with the slave device are
established. When an incorrect mode is selected, turn the
power off and then back on again to change modes.
3
Use USB device mode operations.
◆
NOTE:
• Please refer to the operating instructions supplied with your PC
and software.
4
Press the MODE button to return to regular mode.
◆
NOTE:
• Recording, playback and most of other operations are not
available in the USB device mode.
• When using a Windows PC, install the driver using the supplied
CD-ROM.
2
1,4
